62 research outputs found

    Enhanced reactive power sharing and voltage restoration based on adaptive virtual impedance and consensus algorithm

    Get PDF
    In this paper, power-sharing management control on an AC islanded microgrid is investigated to achieve accurate reactive power sharing. The droop control method is primarily used to manage the active and reactive power sharing among the DGs in the microgrid. However, the line impedance mismatch causes unbalanced reactive power sharing. As a solution a consensus-based adaptive virtual impedance controller is proposed, where the consensus algorithm is used to set the reactive power mismatch; then a virtual impedance correction term is generated through a proportional-integral controller to eliminate the line impedance mismatch. Thus, reactive power sharing is achieved without knowledge of the line impedances or using a central controller. Moreover, the consensus algorithm is used to restore the AC bus voltage to the nominal value by estimating the DGs average voltage using neighbor communication to compensate for the decreased magnitude of the voltage reference. Matlab/Simulink is used to validate the accuracy of reactive power sharing and voltage restauration achievement of the proposed solution through simulation of different scenarios. In addition, a dSPACE DS1104 is used within a developed experimental testbench based on two parallel DGs to validate the effectiveness of the proposed solution in the real world. © 2022 by the authors. Licensee MDPI, Basel, Switzerland

    Comparison of energy transfer between Terbium and Ytterbium ions in glass and glass ceramic: Application in photovoltaic

    Get PDF
    The structural and optical properties of thin layers based on 70%SiO 2 –30%HfO 2 doped with different concentra- tion of rare earth ions (terbium and ytterbium) have been studied with a view to integrating them in a photovoltaic cell as a spectral conversion layer in order to improve its efficiency, by using down-conversion process. These thin films were synthesized by using sol gel technique and deposited on the pure silica substrate by dip-coating method. The DC layer can be placed on the front side of a solar cell and can enhance the current by converting ultraviolet (UV) photons into a large number of visible photons. In present study two series of samples are compared, the first series corresponds to samples treated at 900 °C (glass- S) while the second series concerns samples treated at 1000 °C (glass-ceramic- SC). These series are based on 70SiO 2 –30HfO 2 activated by different molar concentrations of rare earths [Tb + Yb]/[Si + Hf] = 7%, 9%, 12%, 15%, 17%, 19% and 21%. Photoluminescence results of reference samples (without Yb 3 + ) showed an emission from 5 D 4 to 7 F J ( J = 3, 4, 5, 6) level characteristic transitions of Tb 3 + , with a maximum peak in the green centered at 543.5 nm cor- responding to the 5 D 4 →7 F 5 transition. For the co-doped samples a clear NIR PL emission around 980 nm was detected, due to the 2 F 5/2 →2 F 7/2 transition of Yb 3 + ions. From luminescence decay curves of Tb 3 + maximum emission peak ( 7 F 5 →5 D 4 transition at 543.5 nm) we have identified the energy transfer efficiency. The quantum efficiency increases by increasing the total [Tb + Yb] concentration. The most significant yield was achieved with [Tb + Yb] = 19%, the maximum quantum transfer efficiency obtained was 190% for glass-ceramic samples and 161% for glassy one

    Interconnection performance analysis of single phase neural network based NPC and CHB multilevel inverters for grid-connected PV systems

    Get PDF
    This paper presents the interconnection performance analysis of single-phase cascaded H-bridge and neutral point clamped multilevel inverters for grid-connected photovoltaic (PV) applications. Interconnection performance analysis of both inverters was investigated using fixed and variable bands hysteresis current control strategies to ensure a lower current's total harmonic distortion (THD). An intelligent control method based on neural networks was introduced to extract maximum power from the PV modules and to achieve optimal operation of the whole system when connected to the utility grid. Control algorithm was implemented in a microcontroller with interrupt routines priority. Both simulation and experimental results are presented to verify the performance of the proposed control methods. In addition, islanding detection capability of the two topologies was investigated. © 2019 International Journal of Renewable Energy Research

    Comparative study of back-stepping controller and super twisting sliding mode controller for indirect power control of wind generator

    Get PDF
    © 2021 Springer. This is the accepted manuscript version of an article which has been published in final form at https://doi.org/10.1007/s13198-019-00905-7This paper presents the application nonlinear control to regulate the rotor currents and control the active and reactive powers generated by the Doubly Fed Induction Generator used in the Wind Energy Conversion System (WECS). The proposed control strategies are based on Lyapunov stability theory and include back-stepping control (BSC) and super-twisting sliding mode control. The overall WECS model and control scheme are developed in MATLAB/Simulink and the simulation results have shown that the BSC leads to superior performance and improved transient response as compared to the STSMC controller.Peer reviewe

    Optimization of modular machining lines

    No full text

    Synergistic effect of human Bone Morphogenic Protein-2 and Mesenchymal Stromal Cells on chronic wounds through hypoxia-inducible factor-1 α induction

    No full text
    International audienceChronic skin ulcers and burns require advanced treatments. Mesenchymal Stromal Cells (MSCs) are effective in treating these pathologies. Bone Morphogenic Protein-2 (BMP-2) is known to enhance angiogenesis. We investigated whether recombinant human hBMP-2 potentiates the effect of MSCs on wound healing. Severe ulceration was induced in rats by irradiation and treated by co-infusion of MSCs with hBMP-2 into the ulcerated area which accelerated wound healing. Potentiation of the effect of MSCs by hBMP-2 on endothelial repair improved skin healing. HBMP-2 and MSCs synergistically, in a supra additive or enhanced manner, renewed tissue structures, resulting in normalization of the epidermis, hair follicles, sebaceous glands, collagen fibre density, and blood vessels. Co-localization of MSCs with CD31 + cells suggests recruitment of endothelial cells at the site of injection. HBMP-2 and MSCs enhanced angiogenesis and induced micro-vessel formation in the dermis where hair follicles were regenerated. HBMP-2 acts by causing hypoxia-inducible factor-1 α (HIF-1α) expression which impacts endothelial tube formation and skin repair. This effect is abolished by siRNA. These results propose that new strategies adding cytokines to MSCs should be evaluated for treating radiation-induced dermatitis, burns, and chronic ulcers in humans. © 2017 The Author(s)
    • 

    corecore